quick ??
#1
Senior Member
Thread Starter
Join Date: May 2005
Location: Birmingham
Posts: 728
Likes: 0
Received 0 Likes
on
0 Posts
quick ??
I had to replace my turbos due to one going bad, replaced with used stock ones. While I was doing this I went ahead and replaced the radiator with a fluidyne as well. Everything runs fine, and ran fine before I took them off, but now my low coolant light keeps coming on. I have filled it up 3-4 times before I went out and it quits calling and is fine the rest of the day. Then it finally seemed to be ok until the other day I drove probably 100miles(mostly interstate) with no problems. Came back this morning to move it so I could get the daily out for work and the light comes on again. It did go off after 5-10 sec.(and I didn't have time to mess with it.
So should I worry, maybe a line loose(but I get no puddles), or just keep putting fluid in it and see if it quits after a few more attempts then worry?? Again I had no problems with the car at all before the turbo/rad. swap.
So should I worry, maybe a line loose(but I get no puddles), or just keep putting fluid in it and see if it quits after a few more attempts then worry?? Again I had no problems with the car at all before the turbo/rad. swap.
#3
Senior Member
Thread Starter
Join Date: May 2005
Location: Birmingham
Posts: 728
Likes: 0
Received 0 Likes
on
0 Posts
I did some, not as much as the last time I changed the fluid. I just thought it was weird that it was fine after driving once, then this morning it wasn't. I'm probably just getting to worried, and will probably go home and burp it again.
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM