Python 1600 Injectors- any one run them on there fd?
Python 1600 Injectors- any one run them on there fd?
I was given a set of new Python 1600 injectors, but i cant seem to find anything on them here on the forum..
any one run them on there fd? have any experience, or know if they are worth keeping.???
thanks in advance.
(mods please move if needed).
any one run them on there fd? have any experience, or know if they are worth keeping.???
thanks in advance.
(mods please move if needed).
if you are looking to run 1600cc injectors, you can gra up a set of Rx-8 injectors & remove the restrictor plate at the tip of the injector (grind the crimped edge off with a very fine file or grinding wheel/ bench grinder)
then it will be a Bosch 1600cc
then it will be a Bosch 1600cc
thanks everyone.
yea i had a feeling they were shitty... I had to be sure.
i was reading some scary **** on some mitsubishi forums bout they caused engine fires or have had them cut out ... scary ****
well i might get some inj from RC engineering.. but ill look into that rx8 inj set up.
thanks.
yea i had a feeling they were shitty... I had to be sure.
i was reading some scary **** on some mitsubishi forums bout they caused engine fires or have had them cut out ... scary ****
well i might get some inj from RC engineering.. but ill look into that rx8 inj set up.
thanks.
Trending Topics
I wouldn't use that rx8 injector setup. It seems that the amount of flow is determined by how hard you hit it so getting matched sets that flow the same would be a problem.
thewird
thewird
Step 3. Hit it With a Hammer. - Using a punch and your favorite hammer, give the valve tip a whack to move it in its press fit into the armature. Dont be a Nancy Boy...HIT IT!
And there you have it, a 2000+cc injector!
Is it really that easy? Just 3 steps? Well...If you didn't hit it hard enough you may only have a 1500cc injector, and if you hit it too hard and bent the valve you have a leaky non functioning injector.
And there you have it, a 2000+cc injector!
Is it really that easy? Just 3 steps? Well...If you didn't hit it hard enough you may only have a 1500cc injector, and if you hit it too hard and bent the valve you have a leaky non functioning injector.
GT4088R
Joined: Jan 2006
Posts: 467
Likes: 0
From: UK
Here are some injectors from venom. I bet these flow well.
Read the story.
http://personal.inet.fi/kerho/terhi/venom/venom.htm
Read the story.
http://personal.inet.fi/kerho/terhi/venom/venom.htm
Thread
Thread Starter
Forum
Replies
Last Post
The Shaolin
2nd Generation Specific (1986-1992)
9
Sep 14, 2015 07:50 PM
