Proper Compression Reading????
#2
King of the Duct Tape
Join Date: Feb 2001
Location: PA
Posts: 1,177
Likes: 0
Received 0 Likes
on
0 Posts
7kgf/cm2 or 100psi is the minimum compression for the FD. i think it can be as high as 9, but shouldn't vary by more than 1.5 per side. thats straight from the manual. if its the original engine and is above minimum i'd say thats awesome for a 115k engine!
#4
Rotary Enthusiast
Join Date: Feb 2001
Location: Huntington Beach, CA, USA
Posts: 1,025
Likes: 0
Received 4 Likes
on
4 Posts
The "maximum" (ie factory new spec) is 8.5kg/cm^2 according to the shop manual. Also, after '93 the manual was changed to make the minimum 6.0kg/cm^2. I personally know of people in the 6s running around just fine, although the general consensus is that the seperation between chambers is more important than the absolute numbers. Make sure you ask what units they are using, sometimes it is reported in psi, and i've heard of one case where the dealer used a 1-10 scale, which is misleading.
Thread
Thread Starter
Forum
Replies
Last Post