Been trying to remove my primary fuel rail today with limited success. I cant see any way round removing the rats nest and pulling the loom back to give me some access to it. Do i have to go to all this trouble ? If so is there a guide or an easy way to remove the nest ?

While i am there can i remove any of it. So far i have no ACV. No removing the AWS and ISC. The car is still seq and runs the apexi power FC.

Scott

 

I have only managed it by removing the whole rats nest and fuel hard lines. Or at least removing the solenoids and lines.

Anything else IMO would require exceptional skill to not abrade or damage the wiring loom. A damaged loom is *bad*.

Dave

 

Yeah i agree. i really cant see anyway round it. I better take the vac diagram outside and hit it.
The prob is the pipes are so damn brittle. i have bad memories from last time i dabbled

scott

 

use some colored tape for each line.. that should work.... here's a pic of the primary injectors and secondary removed.. .. i didnt remove the vacum lines....