Anyone have a good oil level sensor laying around. I have a question about the connector that connect to the wire harness. Does the connector only have 1 prong at the end of it??

 

Yea I think it does, never took much notice when I had my engine apart the other day but there was only 1 wire I know that

 

lol this thing is notrorious for breaking... both my spare motor and the motor in the car have broken oil level sensors! they are just in a bad high traffic spot. im looking into the pineapple racing pan when i get money and putting the sensor in a safer spot...

 

Single wire - Blue in color - See C-1a electrical drawing in the manual - connector C1-03

later

 

I know mine is broken also. I had a leaking turbo oil return line and ran out off oil one night.

Luckily I saw the oil pressure drop, shut down the car, and coasted right into a PeP Boys parking lot. Soooooooooooooooooooooo Lucky!!

 

I just broke my second one too.
Will the car run OK without it hooked up until i can get one ordered?

 

I wasn't so lucky and fried the side seals on the front rotor and spun a bearing and fried my e-shaft.

 

just a quick one guys,,,how can you tell when its broken,,,,my low oil light is on when i put key in on position,, but when i start car light goes out,,,so i presume its ok,,,but i want to be sure its working,,,any info thanks

 

Both my motors and them broke off when I pulled them. Yes its working if the light goes on then off at start up if you want to see if its working check to see if its still in one peice. it is in the on the drivers side and its on the side of the pan in the middle held in by 3 bolts.

 

yer the thing is still in one piece,,, so mine must be ok, thanks rocking