Nordskog EGT gauge - output to Datalogit?
Thread Starter
Joined: Jul 2003
Posts: 4,678
Likes: 97
From: Bay Area, CA
Nordskog EGT gauge - output to Datalogit?
I'm searching for an EGT sender and found that the Norskog EGT gauge comes with a sender and has a 'programmable output wire'. I'm hoping that this means that I can convince it to send 0-5V to a Datalogit but I can't find any detailed information on this output signal.
Anybody have any experience with this unit?
http://www.siliconeintakes.com/produ...af06be70d8e2dd
Anybody have any experience with this unit?
http://www.siliconeintakes.com/produ...af06be70d8e2dd
Warming the planet.
Joined: Dec 2004
Posts: 845
Likes: 2
From: Chico, CA
The output on that gauge is just a switch.
There's a good thread
https://www.rx7club.com/showthread.p...ht=logging+egt
Paul
.
There's a good thread
https://www.rx7club.com/showthread.p...ht=logging+egt
Paul
.
Thread Starter
Joined: Jul 2003
Posts: 4,678
Likes: 97
From: Bay Area, CA
Thanks. I just found the instructions. You are right - the output wire is just a switch, which certainly stretches the limit of the word 'programmable'.
http://www.nordskogperformance.net/t...ital/M9005.pdf
http://www.nordskogperformance.net/t...ital/M9005.pdf
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
Nov 10, 2018 12:03 PM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
Sep 11, 2015 03:29 PM
