No primary turbo after intake removal
#1
Junior Member
Thread Starter
No primary turbo after intake removal
What could cause there to be little to no primary turbo boost after removing the upper most intake. HKS intake. It is now refitted and everything appears to be attached.
I have about 2 psi of boost right up until 4500rpm then it hits the normal 10psi. This all worked fine until the the upper intake was removed.
I have about 2 psi of boost right up until 4500rpm then it hits the normal 10psi. This all worked fine until the the upper intake was removed.
#2
RX-7 Bad Ass
iTrader: (55)
Check the vacuum lines going to the back half of the Y-pipe. If the charge control valve or charge relief valve have vacuum lines off you would get some weirdness.
Dale
Dale
#3
Junior Member
Thread Starter
#5
RX-7 Bad Ass
iTrader: (55)
That can do it! Glad you sorted it out!
Dale
Dale
Thread
Thread Starter
Forum
Replies
Last Post
Peruvianrx7
Power FC Forum
4
05-22-13 03:51 PM
palsor1
3rd Generation Specific (1993-2002)
2
10-19-10 03:01 PM
DriveFast7
1st Generation Specific (1979-1985)
14
06-09-08 03:10 PM
79+80_rx-7
1st Generation Specific (1979-1985)
11
03-03-03 01:50 AM
mazdaspeed7
2nd Generation Specific (1986-1992)
27
10-27-02 12:21 PM