Well i just got done installing a triple gauge pod and a single pod.

I now have

Autometer:
Water Temp Elec
Oil Pressure
Boost/Vac
EGT

Well i was wondering if these numbers where about right for my mods

Intake
Non-Seq
DP, MP, Catback


Normal Cursing @ 65mph
Water temp is about 185-190F
Oil Pressure is about 75psi
Exhuast Gas Temp is about 900-1000F

When i do a quick run 40-100
Water temp still stays 185-195F
Oil Pressure is about 100-110psi
Exhuast Gas Temp maxed out at 1300(But it reacts kinda slow)


I will post some pics tomarrow about my gauge setup.
Here is a quick rundown

Autometer triple gauge pod
Water Temp Elec
Oil Pressure
Boost/Vac
EGT
Low oil pressure light >18psi
High Water temp 205F on
Fan on Light (Lit-up when fans are on)
Boost Indicator
Over-Boost indicator

Also was able to use the stock oil pressure gauge and water temp

Like i said i will have some pics and a whole write up.
Thanks for Reading and your ideas on normal temps

 

Just thought of something,

CHANGE YOU THERMOSTAT IF YOU DONT NO WHEN THE LAST TIME WAS!

I replaced mine when i pulled the housing for it and the rubber was cracked and missing in parts, could have stuck possible.