3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

New Clutch - Extreme Heat?

Thread Tools
 
Search this Thread
 
Old 07-02-02, 03:12 AM
  #1  
Full Member

Thread Starter
 
209_rx7's Avatar
 
Join Date: May 2002
Location: Merced, CA
Posts: 126
Likes: 0
Received 0 Likes on 0 Posts
New Clutch - Extreme Heat?

I just got a new clutch put in my car today, took it to a tranny shop. Its a ACT street/strip....

Anyway, I was breaking it in today, putting a few miles on it around town and I noticed that the center console between the seats was getting pretty damn hot. I know it got warm before I got the new clutch, but this would be considered hot and not warm.

Anyone know what type of insulation, if any, should be near the shifter to protect heat from the exhaust and the transmission? I am not sure if it should get this hot, considering the 3 switches in the center are also getting pretty warm.....

Anything info will help. Thanks

-Branden
Old 07-02-02, 08:59 PM
  #2  
Rotary Enthusiast

iTrader: (6)
 
rx7will's Avatar
 
Join Date: Feb 2002
Location: San Francisco, CA
Posts: 1,301
Likes: 0
Received 3 Likes on 2 Posts
I'm not sure if its the same but on my TII it has like three rubber boots that fit tightly over the shifter and is bolted down to the body to keep the heat out. The shop might not have put back the boost properly and the heat might be going pass the boots. The boots for the TII were dam expensive, so i can only imagine how much the fds cost.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
The1Sun
New Member RX-7 Technical
5
09-15-15 04:45 PM
sinclair7seven
General Rotary Tech Support
11
09-11-15 10:15 AM
risingsunroof82
1st Generation Specific (1979-1985)
2
09-09-15 08:06 PM
REX7&Z32TT
New Member RX-7 Technical
5
09-09-15 05:16 AM
ZaqAtaq
New Member RX-7 Technical
2
09-05-15 08:57 PM



Quick Reply: New Clutch - Extreme Heat?



All times are GMT -5. The time now is 06:55 PM.