Need some quick help
#1
I'm on a Boat!
Thread Starter
iTrader: (15)
Join Date: May 2003
Location: OK
Posts: 1,824
Likes: 0
Received 0 Likes
on
0 Posts
Need some quick help
Here is my problem: One of my injector is sticking the front primairy. I have the uim off and put a 12v source to the injectors and can hear them open and close. I wanna check the connections before i put it back together. Is there a way to see if power is getting from the ecu to the injectors?
The injector were cleaned and flowtested by RC but they sat for a couple of months before being fired up. And i've read the stuff they clean them with is known to gunk the injector up if they aren't used shortly after they are cleaned.
Thanx
Cyan
The injector were cleaned and flowtested by RC but they sat for a couple of months before being fired up. And i've read the stuff they clean them with is known to gunk the injector up if they aren't used shortly after they are cleaned.
Thanx
Cyan
#3
I'm on a Boat!
Thread Starter
iTrader: (15)
Join Date: May 2003
Location: OK
Posts: 1,824
Likes: 0
Received 0 Likes
on
0 Posts
Thanx for the quick reply. I don't have the manual and www.iluvemyrx7.com stopped working before i could download all the info.
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
Adaptronic MTX-L to adaptronic question
TeamRuffRacing
Adaptronic Engine Mgmt - AUS
1
09-30-15 08:13 PM