need non-seq turbo install help
#1
Rotary Enthusiast
Thread Starter
Join Date: Jun 2002
Location: abingdon, maryland
Posts: 1,447
Likes: 0
Received 0 Likes
on
0 Posts
need non-seq turbo install help
i bought a non-seq converted turbos and had a couple of questions..... the place where the bov goes to is welded off....where do i connect the bov to???? the butterfly is removed on the ypipe.... could i just attach my y pipe with the place for the bov to the part with the removed butterfly??? and one more thing... the hose that connects to the ypipe in the back is also welded off.. should in just leave those hoses off... attached some pics hope they work... and once again thanks for the help in advance.. kevin
#2
Rotary Enthusiast
Thread Starter
Join Date: Jun 2002
Location: abingdon, maryland
Posts: 1,447
Likes: 0
Received 0 Likes
on
0 Posts
Re: need non-seq turbo install help
here's the welding on the back off the pipe.... can i leave the hose that goes there off???... the turbos that connect to the ypipe have only one stud... are they easy to take off themselves and transfered.
#6
Eye In The Sky
iTrader: (2)
Join Date: Feb 2001
Location: In A Disfunctional World
Posts: 7,894
Likes: 0
Received 114 Likes
on
66 Posts
The person who did that is a ******* stupid idiot!
Unless you plan to mount a BOV off the IC piping, you are now forced to use the pipe on the rear half of the "Y" pipe. Which was used for the charge relief valve which is almost like a bov.
Now to the small twin nipples welded off on the engine side of the "Y" pipe outlet. Those has two purposes.
The large one went down to the bottom of the LIM to supply air to the primary injector air bleed sockets which improves the idle. The other was the pressure side supply for the stock or aftermarket boost controller.
Get an Efini "Y" pipe to replace the trashed one you have and gain another .5 to 1psi boost.
Unless you plan to mount a BOV off the IC piping, you are now forced to use the pipe on the rear half of the "Y" pipe. Which was used for the charge relief valve which is almost like a bov.
Now to the small twin nipples welded off on the engine side of the "Y" pipe outlet. Those has two purposes.
The large one went down to the bottom of the LIM to supply air to the primary injector air bleed sockets which improves the idle. The other was the pressure side supply for the stock or aftermarket boost controller.
Get an Efini "Y" pipe to replace the trashed one you have and gain another .5 to 1psi boost.
Last edited by cewrx7r1; 04-08-03 at 10:54 PM.
Trending Topics
#9
development
Originally posted by fd3virgin
yeah, i will just reuse my y pipe. thanks alot. i will wait on the efini ypipe.. i will go single either this winter or next spring.
yeah, i will just reuse my y pipe. thanks alot. i will wait on the efini ypipe.. i will go single either this winter or next spring.
Anyhow, you can vent boost from the CRV nipple (That's one big nipple) just hook the ABV tube up that and run the vac line to the UIM, and use your old y-pipe and just plug the nipple that is pointing up.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM