3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

looking for diameter of tach and speedo

Thread Tools
 
Search this Thread
 
Old 04-21-02, 12:06 PM
  #1  
Junior Member

Thread Starter
 
Riken's Avatar
 
Join Date: Apr 2002
Location: Ontario, Can.
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
looking for diameter of tach and speedo

might retrofit these into another vehicle.

thanx
Old 04-21-02, 01:30 PM
  #2  
WWFSMD

 
maxcooper's Avatar
 
Join Date: Jun 2001
Location: SoCal
Posts: 5,035
Likes: 0
Received 4 Likes on 4 Posts
Get a ruler or tape measure and go measure them.

They aren't normal gauges like you would get from the aftermarket (round, self-contained) but rather they are part of a normal instrument cluster and the cover makes them look like individual gauges.

-Max
Old 04-21-02, 01:32 PM
  #3  
Junior Member

Thread Starter
 
Riken's Avatar
 
Join Date: Apr 2002
Location: Ontario, Can.
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
i would if i knew where one was.

.
Old 04-21-02, 07:25 PM
  #4  
Full Member

 
MastaCow's Avatar
 
Join Date: Aug 2001
Location: Los Angeles
Posts: 85
Likes: 0
Received 0 Likes on 0 Posts
FWIW, I have my gauge cluster here next to me.

I have a ruler I picked up in Korea and can only assume its in cm.

Tach is 107mm roughly, speedo is 95-96 mm roughly. I measured them from the outer edge of the chrome bezel.

But yes, Maxcooper is right (again) There's no way you'll be able to retrofit just those two gauges to another car. All 5 gauges and the idiot lights are on one big chunk of plastic.
Old 04-22-02, 12:38 AM
  #5  
Junior Member

Thread Starter
 
Riken's Avatar
 
Join Date: Apr 2002
Location: Ontario, Can.
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
are the guages self-contained or are they integrated into eachother? Can they be cut apart and make a new front cover. Were the tachs with the 100rpm divisions special edition or such?
Old 04-22-02, 12:42 AM
  #6  
Full Member

 
MastaCow's Avatar
 
Join Date: Aug 2001
Location: Los Angeles
Posts: 85
Likes: 0
Received 0 Likes on 0 Posts
They're integrated, and there's a big piece of circuit film on the back of the piece.

The tachometers with the 100rpm units were on the 93 rx-7's. 94 and 95 had the tachs with less lines.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
pfsantos
2nd Generation Specific (1986-1992)
1
09-30-15 01:29 PM
Thor 18
3rd Generation Specific (1993-2002)
5
09-28-15 07:35 PM
Casual_John
Canadian Forum
4
09-26-15 01:47 PM
subeone
General Rotary Tech Support
0
09-24-15 09:58 PM



Quick Reply: looking for diameter of tach and speedo



All times are GMT -5. The time now is 08:22 PM.