i just recently got my car back from ricks rotary. that guy is awesome. my mods that he did were:

brand new rebuild with 3mm apex seals
street port
act street strip clutch
1300 injectors
upgrade fuel pump
efini y pipe
greddy smic with pettit air duct
hks downpipe
mid pipe
apexi exhaust
apexi intakes
power fc with street tune
rx7 store pulley kit
greddy elbow
all the safety mods were done also

i was wondering what kind of power i should see with the stock twins at 14lbs of boost and what kind of 1/4 times i should shoot for i am a average driver. also what is the car capable with a good driver and slicks in 1/4. thanks for any info

nate

 

I would expect around 320 to the wheels with that set-up.

 

Really?? I would expect more than that...

 

really only 320hp to the wheels. i thought maybe 350 to 380hp to the wheels.

 

I wouldn't think so with the stock turbos, but then again, "I'm not a smart man". [/gump]

 

I recently dyno'd a similar setup. (check the time & dyno section) and made 328 to the wheels.
Non seq twins- heat soaked like crazy (60C+ intake temps)
I could go have it done again at higher boost and reach ~360

 

what 1/4 mile times are you seeing with this set up?

 

so then the most i will expect for is 320 to the wheels on 14lbs of boost? can anyone give me any other numbers to look forward to.

 

Try doing some research:

https://www.rx7club.com/time-slips-dyno-121/dyno-graphs-229717/

https://www.rx7club.com/time-slips-dyno-121/time-slips-229715/