And there's a tube that's right beside the UIM that's open once I took the stock airbox off? I see the intake pipes, the BOV hose, the hose above the BOV hose that's connected to what looks like the BOV but isn't, and then that one pipe by the UIM that I have no idea what it is. What is that and what do I need to do with it?

 

Crv?

 

If your talking about the hard pipe that comes around from behind the UIM just put a rubber cap with 4 holes in it on. I would show you a picture but Dale Clark's website appears to be down...

 

Got it. I think I've seen that how-to before, so I know what you're talking about. What about the black rubber elbow that comes with the kit? I thought it fit onto the bottom intake, as one side fits, but the other end didn't fit anything else that came with the kit.

 

Nevermind, got that elbow in where it should be. Helped once I looked at the instructions. But where does the blue coupler go?

 

which intake kit is this?

 

Greddy Airinx. I can't tell where that blue coupler goes from the pictures people have posted on here. If it's for the top intake pipe, I just used the stock one instead.

 

yep, the blue coupler goes for the top intake pipe, you could juts use the stock coupler if you wanted,

for some reason my top intake pipe hits my hood insulation when i close the hood does yours?

 

Haven't had that problem, at least not that I've noticed. Did you bolt the intakes down or did you just use the couplers to clamp them in?

 

i bolted them down, i didn't notice at first either until after awhile i got the filter imprint/impression on my hood insulator haha

 

I looked today and sure enough, there's a little impression there. Oh well, doesn't seem to be hurting anything else, it'll be okay.