ok i need some pics or insrructions on how to take the injectors out in my 94 fd. i have looked it up and it doesnt seem that hard. but i was wondering if anyone had any pics of taking them. if so please post them up my injectors are leaking really bad
thanks
Sam

 

You'll have an easier time if you just pull the entire rails out. Just disconnect the fuel lines where they go to the rack (I do this so I can unbolt the rack and pull it out of the way a bit). Make sure to label them if you've never done it before.. After that, disconnect the other side where it goes to the FPR and the FPD. Then, disconnect the connectors from the harness, unbolt the rails, and remove. Make sure not to loose the spacer for the primary rail and be careful of the grommets when you reinstall the injectors.

Check this thread:

https://www.rx7club.com/3rd-gen-archives-73/injector-removal-reconditioning-replacement-232603/

 

If you have a compressor and the rails out, I prefer to use air to remove the injectors rather than prying or using pliers and visegrips as that link suggested. Just plug one end of the rail with your thumb and used a rubber tipped air gun. Mine popped right out.

 

great thanks alot guys and thanks for the link

 

Here is a post of mine from a while back, some good pictures and some other optioins to removing them. Hope this helps.

Terry7

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/worked-me-491878/

 

cool thanks alot Terry