Idling Too Fast
There are plenty of threads on high idle problems. Just use the search engine with "idle high problem" and it will pull up a lot of information. Here are a few to get you started:
https://www.rx7club.com/forum/showth...hreadid=123133
https://www.rx7club.com/forum/showth...hreadid=125568
Both threads have a lot of info about troublshooting idle problems. They should get you started.
Good luck.
https://www.rx7club.com/forum/showth...hreadid=123133
https://www.rx7club.com/forum/showth...hreadid=125568
Both threads have a lot of info about troublshooting idle problems. They should get you started.
Good luck.
just real quick responce...I'm dealing with at 1500 rpm fluctuating idle, figure it is a bad solenoid because the workshop manual states that two of the solenoids, when bad, cause a high fluctuating idle. Check for leaks in your vaccum lines, grab some carb cleaner and start spaying....if you idle changes when you spray a hose you found a leak...replaces the hose. Sounds like a lot of people just find hoses not connected. I have sprayed and found no leaks...so I'm moving onto the solenoids when I replace my vac hoses. Also check your UIM gasket, then can go bad and cause a bad idle as well. And if you don't have a workshop manual...download it or buy one..it's a life saver...and a recreation read for most of us on the board it seems
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
The1Sun
1st Generation Specific (1979-1985)
7
Sep 18, 2015 07:13 PM
The1Sun
New Member RX-7 Technical
5
Sep 15, 2015 04:45 PM
RotaryBobby
1st Generation Specific (1979-1985)
1
Sep 10, 2015 01:33 PM




