My rx7 burned and so did my engine and everything that was plastic/gaskets or seals and valves. I stripped all the components of the engine and cleaned it up but it's way too much money to to rebuild along with all emissions and other components. What do I need to do since almost all the components are gone I found I block of kit and I was wondering if you guys could tell me how to get the engine to function with out them.

This is the list

ACV
ACV Tube
AWS
AWS Tube
Double Throttle
EGR
ISC
Split Air
Rear Turbo Oil Return Line
Hex Head Bolts
......

Thanks for your help

 

To install all our block off plates you need to perform a vacuum line simplification, which means you will still need the vacuum/pressure chambers and a few solenoids. If you go non-sequential or single turbo you can eliminate virtually everything and only need a couple vacuum lines.

We recommend installation of a Power FC if you are doing any of the above, since removing the smog pump causes the car to run poorly on the stock ECU.

 

I really appreciate your help. how would I go non-sequential? thanks, yea a power fc is on my list right after I rebuild my engine bay and fuel system. my car came with a pink box from pfs supercars I don't know how good it is but its definitely going.

 

There are multiple how-to's for NS turbo operation on this forum, just use the search button. The best way is to remove the turbos and manifold to do the modification correctly.

 

Here are some of the write-ups I found:

RX-7 Info & How To's

Thank you Robbie!

 

To the OP this is what I am using currently Rotary Resurrection home of the budget rebuild. in order to simplify things as much as possible along with depowering my power steering. You may also want to check out Triple-R: Engine Rebuild - Wiring Harness Rebuild which is also part of my plans. Hope this helps with your build as much as it has with mine so far.

~Spike~

 

Thank you guys

 

Consider an idler pulley to replace the lost AP pulley for better belt contact on the waterpump.

 

If you are going to do an ECU and need a wiring harness since yours is burnt, may want to consider a Haltech or something. Cost may net out. Something to consider.