I don't get it...check engine light
#1
Senior Member
Thread Starter
iTrader: (4)
Join Date: Aug 2004
Location: Chicago
Posts: 516
Likes: 0
Received 0 Likes
on
0 Posts
I don't get it...check engine light
Hi Everyone:
I was about to start my car, and I put the car in the "ON" position and I noticed that the check engine light stayed on. So I shut off the car and opened up the Diagnosis box and used a paper clip to bridge the TEN and GND (the one next to TFA). I turned the key to the "ON" position and waited for an error code...and got nothing. So I pulled off the paper clip and turned the key to the "ON" position and the "Check engine" light stayed on. I'm a bit confused on what's going on...so anyone here can point out something I might be over looking?
I was about to start my car, and I put the car in the "ON" position and I noticed that the check engine light stayed on. So I shut off the car and opened up the Diagnosis box and used a paper clip to bridge the TEN and GND (the one next to TFA). I turned the key to the "ON" position and waited for an error code...and got nothing. So I pulled off the paper clip and turned the key to the "ON" position and the "Check engine" light stayed on. I'm a bit confused on what's going on...so anyone here can point out something I might be over looking?
#5
Senior Member
Thread Starter
iTrader: (4)
Join Date: Aug 2004
Location: Chicago
Posts: 516
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by weetbix13
did you start it? engine diagnosis (the CEL) will normally come on during startup but shut-off once the car is running.
Mr. Moderator, please close this thread.
Thread
Thread Starter
Forum
Replies
Last Post
David Hayes
3rd Generation Specific (1993-2002)
13
09-05-22 12:45 PM