man im pissed, everthing is going good, im doing the vac hose job while im changing out the FPD. i get everything changed out and BAMMMMMM i cant get the screws back in, just wanted to know what you guys used when you did the job my damn fingers are to big. thanks and trust me i tried to search for it nothing on this note

 

I used some hex-head screws from the ACV instead of re-using the philips head ones. If you are re-installing your ACV, then pick some up at the hardware store. Then I used a ratchet with a 2" extension. Make sure you don't tighten one screw and then start the other. As always, get all your screws started by just a few threads and then tighten them all a little at a time.

 

i got some 5mm hex but didnt know if i shoud use the lock nut and washer that the oem had

 

I used a spring washer and a regular S/S washer. I doubt the FPD could ever come loose, but I put the washers on there to make sure the screws don't bottom out in the screw hole.

Did you get it on?