How did you reinforce your Power Plant Frame?
#2
AponOUT!?
iTrader: (31)
There are a several threads about this already, with lots of photos. Please search before starting new threads.
https://www.rx7club.com/3rd-generati...ed-ppf-527280/
https://www.rx7club.com/3rd-generati...anyone-979854/
https://www.rx7club.com/3rd-generati...cement-914783/
https://www.rx7club.com/3rd-generati...ed-ppf-527280/
https://www.rx7club.com/3rd-generati...anyone-979854/
https://www.rx7club.com/3rd-generati...cement-914783/
#3
In Surgery
iTrader: (17)
Transmission and diff bracing are probably your best bet. Cryo treatment is more for parts that you are looking to reduce wear on which in also hardens the parts. In the case of the PPF I dont believe it would be a good Idea to harden it because it is always under torsional stress and after all it is only a thin sheetmetal part. The process of cryo treating can also create cracks in the object.
The following users liked this post:
Nakd n Fearless (07-08-19)
#6
Committee Member #2
iTrader: (29)
I recently had my local welder "reinforce" my PPf about a week ago.
Basically what I had him do was weld all the "X" areas to the center just like one of the threads that Theorie pointed to. I also had him weld the plates together around the "ears" of the PPF. If you look closely, you will see the ends have 2 plates of steel that are just seem sealed and spot welded. I figure by welding the 2 plates together it will keep them from splitting and cracking the PPF.
Also, I have both the Banzai diff brace and tranny brace for even more security.
Good luck
Basically what I had him do was weld all the "X" areas to the center just like one of the threads that Theorie pointed to. I also had him weld the plates together around the "ears" of the PPF. If you look closely, you will see the ends have 2 plates of steel that are just seem sealed and spot welded. I figure by welding the 2 plates together it will keep them from splitting and cracking the PPF.
Also, I have both the Banzai diff brace and tranny brace for even more security.
Good luck
#7
I recently had my local welder "reinforce" my PPf about a week ago.
Basically what I had him do was weld all the "X" areas to the center just like one of the threads that Theorie pointed to. I also had him weld the plates together around the "ears" of the PPF. If you look closely, you will see the ends have 2 plates of steel that are just seem sealed and spot welded. I figure by welding the 2 plates together it will keep them from splitting and cracking the PPF.
Also, I have both the Banzai diff brace and tranny brace for even more security.
Good luck
Basically what I had him do was weld all the "X" areas to the center just like one of the threads that Theorie pointed to. I also had him weld the plates together around the "ears" of the PPF. If you look closely, you will see the ends have 2 plates of steel that are just seem sealed and spot welded. I figure by welding the 2 plates together it will keep them from splitting and cracking the PPF.
Also, I have both the Banzai diff brace and tranny brace for even more security.
Good luck
Tomorrow, I will fabricate a brace like that, do you think it'll help?
https://www.rx7club.com/3rd-generati...-brace-729730/
Thanks guys!
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post