Hope im not running lean!!!!!!!!help
Hope im not running lean!!!!!!!!help
Just got exaust installed in mya car. I dont have an upgraded ecu, do u think im going to have any problems leaning out while running a DP, CB and high flow cat? Or is the high flow cat going to keep enough backpressure that my turbos wont creep? Also whats the highest boost level the stock ecu map can compinsate for? Also i dont have an intake if that helps.
Theoretically one of those could be enough to blow the engine, but luckily the factory runs them rich to begin with.
The three mod rule is a safety net, but if I were you, I would 1> keep the boost down (using your right foot if you have to) 2> get an ECU pronto.
The three mod rule is a safety net, but if I were you, I would 1> keep the boost down (using your right foot if you have to) 2> get an ECU pronto.
dp,cb,hfc
no problem, but no boost spikes allowed. need bigger pill for wg actuator, to keep near stock boost. rx7.com had staged pills at one time.
can also add intake. but big IC or mid-pipe are not allowed w/o ecu upgrade, esp if other mods are done.
no problem, but no boost spikes allowed. need bigger pill for wg actuator, to keep near stock boost. rx7.com had staged pills at one time.
can also add intake. but big IC or mid-pipe are not allowed w/o ecu upgrade, esp if other mods are done.
Trending Topics
Typically the stock ECU should be able to handle 3 mods. That is a good baseline to run off of. Being that all of your 3 mods are increasing the same system (exhaust system) this may be a little bit different. Try going with an upgraded ECU if possible, or just stick with a DP for now...
I'd wait on the other 2 until you get an ECU, and once you do that send some more air to the car, get a cold air intake system...
I'd wait on the other 2 until you get an ECU, and once you do that send some more air to the car, get a cold air intake system...
Thanks for all the responces ur input has helped alot. Im taken off the HFC on sunday, unless anyone can tell me how to ajust my wastegate so my turbos stay at 10 psi and dont spike.
"What's with the exclamation marks????
You know, that could be considered shouting and f'ing rude. Especially for a newbie."
And to TwinTurboTeddy
Whats with the Attitude?
You know that IS f'ing rude. Considering ur a "pro" and have all this f'ing knowlege, instead of being a d!ck about things u could be helpful and voice an opinion wearth me reading. If not u can go F@%K!!!!!!!!!!!!!! yourself and your F'ing opinon.
"What's with the exclamation marks????
You know, that could be considered shouting and f'ing rude. Especially for a newbie."
And to TwinTurboTeddy
Whats with the Attitude?
You know that IS f'ing rude. Considering ur a "pro" and have all this f'ing knowlege, instead of being a d!ck about things u could be helpful and voice an opinion wearth me reading. If not u can go F@%K!!!!!!!!!!!!!! yourself and your F'ing opinon.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
smikels
2nd Generation Specific (1986-1992)
3
Aug 18, 2015 01:26 PM



