hold light flashes after a hard run? what gives?
#1
Rotary Enthusiast
Thread Starter
Join Date: Jun 2003
Location: colorado
Posts: 1,400
Likes: 0
Received 0 Likes
on
0 Posts
hold light flashes after a hard run? what gives?
Ok so Ive recently noticed something weird.After a couple of hard runs Ive noticed that the hold mode dissables itself.Does the ecu for the tranny have some sort of procedure for dissableing the hold feature if for example the tranny gets to hot or anything like that.I think both times it happened when I downshifted.
Also after a little while the hold light stops falshing and then I can re engage the hold system.Really weird.Ive noticed this just recently.What could this be?
Also after a little while the hold light stops falshing and then I can re engage the hold system.Really weird.Ive noticed this just recently.What could this be?
#5
Rotary Enthusiast
Thread Starter
Join Date: Jun 2003
Location: colorado
Posts: 1,400
Likes: 0
Received 0 Likes
on
0 Posts
yeah.It just worries me that it does this.So im going to try and figure out whats going on.Most likely my atf fluid is probably low.By the way what kind of atf does the tranny take and also where do you fill it up? through the dipstick tube?
Thread
Thread Starter
Forum
Replies
Last Post
David Hayes
3rd Generation Specific (1993-2002)
13
09-05-22 12:45 PM
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
smikels
2nd Generation Specific (1986-1992)
3
08-18-15 01:26 PM