Help!!got no spark in front rotor!
#1
Help!!got no spark in front rotor!
Im running into a problem and im running out of ideas! I have a 94 rx7 that im building for my daily driver, but the car wont start anymore. Its happen last week when I was at my body shop that I work at doing some repairs on the panels. The car run fine until I left the shop. Its ran rough, like its running on one rotor. Also notices that the gas gauge needle drop to the bottom.So I quickly when back to the shop. It kept dying on the way over there and its will smoke, but it smell like unburn fuel.
The next day I change the fuel pump and fuel filter... nope not it!! the very next day changed the igition coils, igniter, fuel pump resistor,and the relays off my other rx7 that runs perfect. that didnt do ****! so I change the spark plug wires and plug. And i saw that the old plug are flooded.
So, today I check each wire with a spark plug tester and found that the both trailing and leading on the front rotor are not sparking ( t1 and l1)
So, Im lost on the next steps.
The next day I change the fuel pump and fuel filter... nope not it!! the very next day changed the igition coils, igniter, fuel pump resistor,and the relays off my other rx7 that runs perfect. that didnt do ****! so I change the spark plug wires and plug. And i saw that the old plug are flooded.
So, today I check each wire with a spark plug tester and found that the both trailing and leading on the front rotor are not sparking ( t1 and l1)
So, Im lost on the next steps.
#4
#7
Trending Topics
#8
no problem! I would suggest the easiest way to fix that is to remove your driver side fender which would involve removing your front bumper.. after that the harness should be fully exposed and make sure that after you fix it.. tuck it up with zipties of some sort as high as you can so it wont happen again.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM