3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Ha!!! Stupid Isc

Thread Tools
 
Search this Thread
 
Old 11-11-04, 01:56 PM
  #1  
I'm sorry wha?

Thread Starter
 
Xeros's Avatar
 
Join Date: Aug 2003
Location: Wisconsin
Posts: 1,098
Likes: 0
Received 1 Like on 1 Post
Ha!!! Stupid Isc

wELL i PULLED OFF THE uim TODAY AND TO NO SURPRISE MY isc WAS STUCK OPEN! Woops caps.So I will simply clog it up with something and get block off plates later on and hope it doesn't bother me again. Are there an side effects when taking the ISC off? I did a search didnt find much at all. I mean it stabilitates idel but other then that is there any side effect?
Old 11-11-04, 02:41 PM
  #2  
5yr member, joined 2001

 
JONSKI's Avatar
 
Join Date: Dec 2001
Location: Marco Island, FL
Posts: 908
Likes: 0
Received 1 Like on 1 Post
From page F-81 of the FSM (you can tell it's authentic by the bad grammar):
Idle speed control (ISC) system controls the bypass air amount that passes through the throttle valve, the idle-speed control system performs feedback control so that engine idle smoothly and at target speed. The system also performs the function of the AAV (Anti-afterburns valve), there by eliminating the AAV and simplifying deceleration control system.
This ISC is operated by a signal from the ECU. It's supposed to maintain 700-800rpm, and 1000rpm under electrical load or when the A/C is on. It's also responsible for the infamous "idle bouncing". Getting rid of the ISC and AWS will let you manually control your idle, but it will lower if you pull up on the gas pedal (if you haven't recently changed your throttle cable) or turn on all the gadgets inside the car.
Old 11-11-04, 03:55 PM
  #3  
I'm sorry wha?

Thread Starter
 
Xeros's Avatar
 
Join Date: Aug 2003
Location: Wisconsin
Posts: 1,098
Likes: 0
Received 1 Like on 1 Post
What do you mean it will lower if i pull on the gas?
Old 11-11-04, 07:06 PM
  #4  
5yr member, joined 2001

 
JONSKI's Avatar
 
Join Date: Dec 2001
Location: Marco Island, FL
Posts: 908
Likes: 0
Received 1 Like on 1 Post
Pull the accelerator pedal towards you. I can do it on my car it takes a few minutes for the ECU to compensate and raise the idle back to where it should be.
Old 11-11-04, 07:49 PM
  #5  
BOOOYAHHHH!

 
RX7Wishing's Avatar
 
Join Date: Feb 2004
Location: Virginia Beach
Posts: 1,578
Likes: 0
Received 1 Like on 1 Post
Originally Posted by JONSKI
Pull the accelerator pedal towards you. I can do it on my car it takes a few minutes for the ECU to compensate and raise the idle back to where it should be.

just make sure your throttle cable isnt overly tight and you shouldnt have to worry about that.
Old 11-11-04, 08:05 PM
  #6  
I'm sorry wha?

Thread Starter
 
Xeros's Avatar
 
Join Date: Aug 2003
Location: Wisconsin
Posts: 1,098
Likes: 0
Received 1 Like on 1 Post
okay thanks fpr the help you guys!

Xeros
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Adaptronic Engine Mgmt - AUS
15
05-19-22 10:44 PM
vish86
Interior / Exterior / Audio
3
10-01-15 11:53 PM
Auroraw0lf
New Member RX-7 Technical
5
09-15-15 04:55 PM
msilvia
3rd Generation Specific (1993-2002)
15
09-11-15 12:13 PM



Quick Reply: Ha!!! Stupid Isc



All times are GMT -5. The time now is 05:45 AM.