fd cuts out when making left turn...
#1
Full Member
Thread Starter
fd cuts out when making left turn...
need a bit of help here. this may seem strange, but when i go to make a left turn the motor starts to sputter...if i dont rev it up it will stall and die. never does it when turning right.
still a bit of a noob to rotaries, but i searched thru a few pages. any help would be appreciated. thx in advanced.
also, horn honks when i pull back the lever to flash the high-beams
still a bit of a noob to rotaries, but i searched thru a few pages. any help would be appreciated. thx in advanced.
also, horn honks when i pull back the lever to flash the high-beams
#6
Senior Member
iTrader: (7)
On my Subaru (GC) I had similar issues but on right turns and with < 1/4 tank of gas; the problem was from fuel sloshing to the other side of the tank and starving the pump. Do the 7's experience the same issues or is there a "basket/anti sloshing" tray inside the tank? Sorry I've never looked inside my tank :P
#7
Rotary Freak
iTrader: (5)
On my Subaru (GC) I had similar issues but on right turns and with < 1/4 tank of gas; the problem was from fuel sloshing to the other side of the tank and starving the pump. Do the 7's experience the same issues or is there a "basket/anti sloshing" tray inside the tank? Sorry I've never looked inside my tank :P
Topic has been covered , in the FAQ
https://www.rx7club.com/race-car-tec...utions-621927/
=0 enjoy
Trending Topics
#10
Eats, Sleeps, Dreams Rotary
iTrader: (19)
Luckily there is a shop AT the track that specializes in FD3Ss and they found and fixed my (Main harness shorting out) problem within a couple days. Thanks 7's Only Racing!
Thread
Thread Starter
Forum
Replies
Last Post