FD cuts off while powerfc learning and fans come on
#1
Junior Member
Thread Starter
FD cuts off while powerfc learning and fans come on
Like the title says- I have a relatively low compression engine, but even low compression across the board.
Cold starts are no issue, hot starts are difficult but car will start. When I start the car and the powerfc goes into "learning mode"- all is fine until the cooling fans come on. At that point, the car will die and idle will not properly learned. Any advice? I already have it idling at over 1400 rpms to get it to get that far.
Cold starts are no issue, hot starts are difficult but car will start. When I start the car and the powerfc goes into "learning mode"- all is fine until the cooling fans come on. At that point, the car will die and idle will not properly learned. Any advice? I already have it idling at over 1400 rpms to get it to get that far.
Thread
Thread Starter
Forum
Replies
Last Post