Would you guys have a clue as to why on my greddy e-01 I cannot even access the boost setting although I have now connected the boost control solenoid and the pressure sensor. Any idea what I should look at or does it sound like a bad boost solenoid.

I hooked up the electrical connections a week ago and the e-01 started displaying correct rpms. Today I installed the boost pressure sensor and the boost control solenoid. The pressure shows correctly also but the boost menu cannot even be accessed.

Any help would be appreciated....

Thanks guys...

 

did you try this?

 

You most likely need to set it to manual control in the settings, otherwise you can't manually input parameters.

 

The issue was that it was a display unit for emanage only and the boost control kit was ordered seperately. The E-01s display would just not show the boost menus at all. So I checked and finally found out that I needed to download from the internet and update the firmware of the E-01 using the SD card that was in it... and after that all the menus started showing...

There is a yahoo group for e-01 support where the firmware can be found

I hope this helps someone....