Hi everyone... I am trying to put a Haltech IC7 on my FD... and I am sorting out the wiring and stuff... have found most of the wires from the instrument cluster except the Driving/Parking Light wire... can someone please tell me which plug and which wire?? I have been reading the wiring diagram and being such a idiot with wirings and electric.. I appreciate the help...

Thanks alot...

 

OP. Did you ever find it? I’m in the same boat.

Everything but that wire location is shown.

 

OP. Found the answer.

see attachment from previous member.

basically parking lights occur in most dash harness as Red/Black.

I connected to 2G

but I supposed you can also connect to 1H or 4B

good luck.

 

Sorry for the late reply.... I finally got it work on wire 2G... Thanks alot man... got it sorted and I got most of it working... parking light.. .high beam.... turn signal.... but the handbrake.... I use the wire 4J..... but it is on no matter if the handbrake is up or down.... Have you got the handbrake light to work?

 

I had the same issue and skipped the handbrake. My car was completely rewired and I took off the center panel to confirm the handbrake harness was no more. 😆. Suggest you look and see if the handbrake is connected by harness to the dash harness. If not, just skip it. Not an important one.

 

Wish I can do the same... I am going in for a government motor vehicle inspection due to loud exhaust.... They go through everything.... So skipping it is not working for me... Worst case i have to put the stock cluster back for the inspection....

 

fake it.

But first check if your wiring is intact and check for continuity.

Then if not, Put your own circuit in that contacts when handbrake is engaged.

 

OP. What are you doing for speedo and fuel level? I have my ic7 Speedo running directly from VSS to ic7. Seems to be working well but I am curious.

my fuel level sensor is a whole other matter.