Apologies ahead of time if this has already been documented elsewhere but I am trying to determine if there are any fitment issues with the Corbeau A4 seats using the Corbeau FD rails. The seat fitment thread indicates they should fit but I spent around an hour searching for a thread with an actual picture or confirmation that they don't rub the door panels, have issues reclining, or sliding back. Again, sorry if I missed it, but can someone confirm the above questions and/or post some pictures? I'm looking for a solid aftermarket reclining seat to replace my torn tan seats and these look like good options assuming they fit.

Here's the dimensions:


Link for reference: https://www.summitracing.com/parts/csu-60091pr

 

I installed one on the driver side only as my R1 seat was never comfortable for me.
Have had mine since 2003 but I purchased the smaller version that was 18.5" wide on the base/butt.
I did get the brackets but modified them to lower the rear more. Had to change the centering holes to move the seat to one side for better fit.
Back then they only had polyester cloth covered seats. Thus I had mine covered in Porsche dark gray leather.

 

Thanks for the response! I wasn't able to find the 18.5" versions at this point and ended up going with the Sparco R100s. The seats and mounts have arrived but I'm waiting on the tracks before I test fit. I will for sure post up the results in a new thread for everyone else once I've got them test fitted.