My mods are as listed: new Pineapple racing street ported motor with stage 2 oil mods, flowed and matched injectors, new oil injectors and lines, brand new 99 efini turbo setup, magnecore 10mm. wires, ngk plugs, jacobs ign.amp.,k&n filters, fluidyne radiator, M2 ecu, M2 downpipe, Greddy power extreme cat back, cosmo fuel pump, RPS street clutch, ACT 9.5 lb chromoly flywheel, short shifter, greddy BOV, turbo timer, VDO boost-oil temp.-water temp. gauges, i have done a full silicone replacement, check all solenoids, couplers etc... My gauge reads the 12-11-14 pattern but the car does not pull on the primary even though the boost shows on the gauge. I believe the problem to be possibly ignition! Any one able to assist?????????????

 

Does the ignition feel like it's breaking up or can you tell if a plug or two isn't sparking? Just wondering why you think it's ign related.

 

It does not feel like it is breaking up, it just does not pull. There is no boost leak or I could tell on the gauge. The boost holds strong until transition, then it just spikes. The spike im not worried about because it is common with the mods I have and I will reduce that by playing with the pills or porting the wastegate. I just wish I could figure out the boost issue. After spending probably 12,000 on the motor, turbos, and all the other stuff over the winter im ready to enjoy the car!

Thanks for any help guys!

 

Help? Boost is 12-11-14, and no one seems to be able to help me!!!!!!!!!!!!!!

 

https://www.rx7club.com/3rd-generation-specific-1993-2002-16/primary-boost-help-335698/