Block off plate question
#1
Senior Member
Thread Starter
Join Date: Aug 2002
Location: Hawaii
Posts: 602
Likes: 0
Received 0 Likes
on
0 Posts
Block off plate question
I have a block off plate kit yet i don't know where most of them go.. anyone have any pics of where they go? so far i've only used the one for the AVCR and the one under the upper intake manifold it's 13BREW ISC/BAC Solenoid i don't plan on removing the AWS system, but yah i am doing the simplification so any suggestions would be great
#6
Rotary Enthusiast
Join Date: Mar 2002
Location: DE, Taiwan
Posts: 751
Likes: 0
Received 0 Likes
on
0 Posts
The AWS doesn't really do anything good, especially if you have a downpipe. At least nothing worth saving it for. Most people prefer to remove it since just about everyone is starting their cars in gear and/or blipping the throttle to prevent it from running its cycle before the car is warmed up. I would get ride of it just to make things easier.
There should be two plates that go right underneath the upper manifold- in the middle of it. Then there's another one for double throttle. There's one on the back edge of the lower manifold where the hose to the main cat connects, and another one on the outer surface of the lower manifold for the EGR valve. I know there's like 9 total including the oil plates.
There should be two plates that go right underneath the upper manifold- in the middle of it. Then there's another one for double throttle. There's one on the back edge of the lower manifold where the hose to the main cat connects, and another one on the outer surface of the lower manifold for the EGR valve. I know there's like 9 total including the oil plates.
Trending Topics
#12
Tony Stewart Killer.
iTrader: (12)
widebody I took care of that, removed them and they are in the small clear ziplock bag (read those instructions in each bag it will help you out...
with the dust and **** (who knows what else is in there but the metal is out foshooo you gotta make sure to clean out all this **** with an air compressor. dont think your motor would appreciate it.
with the dust and **** (who knows what else is in there but the metal is out foshooo you gotta make sure to clean out all this **** with an air compressor. dont think your motor would appreciate it.
#16
Speed Mach Go Go Go
iTrader: (2)
Join Date: Oct 2001
Location: My 350Z Roadster kicks my RX7's butt
Posts: 4,772
Likes: 0
Received 2 Likes
on
2 Posts
Originally posted by evot23
Last edited by GoRacer; 04-22-04 at 10:17 PM.
Thread
Thread Starter
Forum
Replies
Last Post
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM