I just finished doing all my vac hoses with silicon. I have a blue electrical connector that is at the front of the motor and in between the alternator and the air pump. I have no idea where it goes. When I start my car the check engine light comes on so I am guessing that that is the problem. If any one knows where the connector goes please help me. Thanks a lot.

Adam P

 

I did unhook the battery. Do I need to reset the diagnostic computer or something. Thanks

AdamP

 

Reset the computer by taking the ground off the battery for about 20 seconds. Do another diagnosis by jumping the ten and ground, turn your key on and count the engine light flashes. Long flashes are tens and short flashes are ones. Get the number of the code and check it with your manual to see which connector it is.


Later,

 

Sorry I don't understand what I am suppost to jump to to a diagnosis.

AdamP

 

Go here.
http://www.rx7city.com/ecucodes.htm

 

I think this is what you are looking for. There is an EGR accuator above the turbos next to the pipe going to the IC. Two wires connected to a sensor go to the accuator.Wires Black and Green connect to wires Brown W/Black stripe and Blue W/Green stripe. Not %100 sure of exact wire color.It was quicker to look at my engine rather than the book.
Rick

 

By close inspection of the wiring diagrams in the shop manual I have found that it goes to the EGR that should be on the center rotor housing. Good news is that it is for Cali cars only, so On most cars I don't think it is supposed to be pluged in.

AdamP