Does anyone have the Gates part #?

 

ALL YOU NEED IS THE BELT?

CAUSE YOU CAN GET THE KIT... COMES WITH THE ALTERNATOR PULLEY AND WATER PUMP PULLEY WITH THE BELT....

http://www.rx7store.net/product_p/rx...%20pulleys.htm

 

https://www.rx7club.com/showpost.php...5&postcount=23

 

I already have the pulley's just need the belt. From what Mahjik sent, seems like it is 30"

 

http://www.pineappleracing.com/index...PROD&ProdID=39

 

Would 30" also be the size for the Unorthodox pulley set with out air-pump?

 

Probably not. My setup was the Pettit Racing underdrive main pulley with the airpump eliminator pullies (alt & waterpump). The belt size I used was a 28.5" 4 rib. I would imagine the Unorthodox pulley to yield similar results. If you have the stock alternator and waterpump pullies, then you'll need to adjust further (as they will be smaller pullies).

Just take some string and run it around where the belt should go. Then measure the length of the string you just use to trace the route and you'll have the approximate size you need for a belt.

 

That would be for an FC

 

or you guys that need belts and dont know the size just use a piece of string and mesure around where the belt would go.

thats wat i did to find out the size of my new powersteering belt with out the a/c.

 

I'm looking to replace both of my belts, and have the air pump eliminated. I'm using the Unorthodox Racing pulleys+Greddy W/P pulley, so one belt would be the Greddy W/P, the UR Main, and the UR Alt. The other belt would be the UR Main, idler pulley, and the UR P/S. Anybody have any idea on the size of those belts?

 

You'll probably be around 28.5". However, you should measure with a string to get the correct sizing.

 

This would be belt #1 and #4

http://www.banzai-racing.com/products_FD_belts.htm