3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

Annoying rattle fixed

Thread Tools
 
Search this Thread
 
Old Sep 8, 2005 | 11:30 AM
  #1  
adam c's Avatar
Thread Starter
Cheap Bastard
iTrader: (2)
 
Joined: Sep 2002
Posts: 8,368
Likes: 50
From: San Luis Obispo, Ca
Thumbs up Annoying rattle fixed

I can't speak for everyone, but I bet most of us are annoyed by those little rattles that we hear when going over bumps in the road. Sometimes we can find them. Sometimes we can't. I have been hearing one for quite a while, but never could figure out where it was. I was hearing it from the passenger side, somewhere behind the seat. I thought it was something behind the panel, so I pulled it off, and found nothing loose. That was a few months ago.

Yesterday, I decided to look at the jack assembly. It turned out that the jack handle was the culprit. The tubular plastic fits loosely on the jack handle, and rattled when going over bumps. I found an empty one gallon milk container, and cut out a 1/2" X 2" section. Then I slid the plastic in between the tube on the jack handle, and the metal. This will hold things snugly, and no more rattle.

I hope this helps someone
Reply
Old Sep 8, 2005 | 11:52 AM
  #3  
dgeesaman's Avatar
Moderator
Tenured Member: 20 Years
Liked
Loved
iTrader: (8)
 
Joined: May 2002
Posts: 12,313
Likes: 27
From: Hershey PA
Nice - I bet mine has the same noise. Now here's a bigger challeng - come to PA and find the electrical short in my wiring harness.

Dave
Reply
Old Sep 8, 2005 | 12:00 PM
  #4  
DrunkenGimp's Avatar
Full Member
Tenured Member 10 Years
iTrader: (3)
 
Joined: Jan 2005
Posts: 236
Likes: 0
From: California
NICE, probably one of the many things rattling in my car >_<. Anyone else have any simple things to fix rattling?
Reply
Old Sep 9, 2005 | 01:54 AM
  #5  
spurvo's Avatar
don't race, don't need to
Tenured Member 05 Years
 
Joined: Oct 2002
Posts: 1,292
Likes: 1
From: Tri-Cities, WA
I have this horrible rattle in my dashboard, right under the defrost vent. Only ratles when there's wind through the system... weird. Prolly have to pull the entire dash, huh?

Also the driver's seat belt retraction nechanism. My FC had the same buzz, feels like an old friend....
Reply
Old Sep 9, 2005 | 02:31 AM
  #6  
4CN Air's Avatar
DETH TRP
Tenured Member 10 Years
iTrader: (7)
 
Joined: Mar 2004
Posts: 2,544
Likes: 0
From: Manhattan Beach, CA
Originally Posted by spurvo
Also the driver's seat belt retraction nechanism.
Dealer's may be obligated to fix this, I'd check. I know Acura and Toyota do.
Reply
Old Sep 9, 2005 | 05:21 AM
  #7  
Sgtblue's Avatar
Urban Combat Vet
Tenured Member: 20 Years
Liked
Loved
Community Favorite
iTrader: (16)
 
Joined: Oct 2003
Posts: 12,160
Likes: 983
From: Mid-west
A bit of upholstery foam that I had laying around the garage worked nice for me. Clear adhesive silicone caulk works great on most plastic interior rattles too.

Last edited by Sgtblue; Sep 9, 2005 at 05:24 AM.
Reply
Old Sep 9, 2005 | 10:23 AM
  #8  
Mahjik's Avatar
Mr. Links
Tenured Member 20 Years
iTrader: (1)
 
Joined: Aug 2001
Posts: 27,595
Likes: 43
From: Kansas City, MO
Good stuff Adam.

I've been telling people for years to check the jack accessories first when looking for rattles in the rear (then move onto pillow ***** and such). As usual, no one listened to me.
Reply
Old Sep 9, 2005 | 04:47 PM
  #9  
4CN Air's Avatar
DETH TRP
Tenured Member 10 Years
iTrader: (7)
 
Joined: Mar 2004
Posts: 2,544
Likes: 0
From: Manhattan Beach, CA
all of mine is gone, rattle fixed!
Reply
Old Sep 9, 2005 | 08:47 PM
  #10  
RX 4 Speed's Avatar
1993 VR FD Touring
Tenured Member 05 Years
 
Joined: Jun 2004
Posts: 650
Likes: 0
From: USA
Another thing that rattles, sounds like it's from the front dashboard, by the vents, kindda sounds like a squeak-squeak, gets loud when traveling on city streets. Turns out it's the hood latch. To fix it, I applied a little duct tape around the latch that gets hooked by stationary hook in the engine bay. Squeak/rattle is gone!!! Hope that helps someone too.
Reply
Old Sep 10, 2005 | 09:14 AM
  #11  
13Foxtrot's Avatar
Raining 120mm fury
Tenured Member 05 Years
 
Joined: Nov 2004
Posts: 182
Likes: 0
From: NC
I've got an extremely annoying rattle that sounds like its coming from somewhere behind the engine but on the downpipe side. It's very noticeable when I am downshifting or just slowing down to less than 15mph. It sounds so much like a piece of aluminum tapping the hell out of another piece of metal. I discovered that several of the bolts to my ABS and it's heat shield had sheared off, but even after I replaced those; it didn't make a bit of difference. Any ideas? Thanks!
Reply
Old Sep 10, 2005 | 10:37 AM
  #12  
dgeesaman's Avatar
Moderator
Tenured Member: 20 Years
Liked
Loved
iTrader: (8)
 
Joined: May 2002
Posts: 12,313
Likes: 27
From: Hershey PA
Pass side motor mount heat shield, or manifold heat shield, or turbo heat shield, or...

Dave
Reply
Old Sep 10, 2005 | 10:44 AM
  #13  
4CN Air's Avatar
DETH TRP
Tenured Member 10 Years
iTrader: (7)
 
Joined: Mar 2004
Posts: 2,544
Likes: 0
From: Manhattan Beach, CA
Originally Posted by 13Foxtrot
I've got an extremely annoying rattle that sounds like its coming from somewhere behind the engine but on the downpipe side. It's very noticeable when I am downshifting or just slowing down to less than 15mph. It sounds so much like a piece of aluminum tapping the hell out of another piece of metal. I discovered that several of the bolts to my ABS and it's heat shield had sheared off, but even after I replaced those; it didn't make a bit of difference. Any ideas? Thanks!
this was my problem, nice easy fix. Boost response was better after the fix too.
https://www.rx7club.com/3rd-gen-archives-73/fixed-my-rattel-noise-here-what-242309/
Reply
Old Sep 10, 2005 | 11:13 AM
  #14  
RX7 Japan's Avatar
Full Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 123
Likes: 0
From: Italy
My trunk has a squeeeeeky noise, not a rattle noise. I can't figure it out. Kinda hard to drive it and look at the same time. Any ideas?
Reply
Old Sep 10, 2005 | 12:27 PM
  #15  
rajeevx7's Avatar
2 FD's since '98
Tenured Member 20 Years
iTrader: (11)
 
Joined: Jun 2002
Posts: 1,598
Likes: 7
From: West Palm Beach
For the hatch,
loosen the latching mechanism on the body side and slide it a little lower. Also, raise the bump stops with some washers. These combined give the hatch a tight closure.

One of the top mounting bolts for my Koni's, the one that tightens the rubber donut had come loose and rattled before I fixed it.

Rear-view mirror rattle.....could not figure it out, so I got a new rearview.

Interior dome light rattle....after several attempts to deaden the rattle, adjust clips so it mounted tighter I eventually flipped it around (backwards) and now it fits too snug to rattle.

Door panels.....the plastic pin-clips that hold the lower window/door threashold had some broken, and were rattling around in the metal door frame holes. Fixed them.

After market shifter....tighten those allen screws down

Slight noise coming from steering column covers.....got new ones with all pins/clips intact.

Rear end clunk was finally repaired by replacing all stock suspension parts and adding Koni shocks.

Just off the top of my head....but, if it's not one thing with this car it's another!
Reply
Old Sep 10, 2005 | 06:11 PM
  #16  
BlueRex's Avatar
Rotary Freak
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 2,444
Likes: 0
From: Bay Area, CA
Originally Posted by rajeevx7
After market shifter....tighten those allen screws down
And use locktite so they don't come loose again.
Reply
Old Sep 10, 2005 | 06:20 PM
  #17  
teeter's Avatar
Senior Member
Tenured Member 05 Years
 
Joined: Oct 2003
Posts: 359
Likes: 0
From: Northwest
little phillips screw that holds the seat reclining handle tight comes loose and then the handle rattles

john
Reply
Old Sep 11, 2005 | 03:33 PM
  #18  
mr.veilsidewankel's Avatar
ONLY FD OWNER IN MY STATE
Tenured Member 15 Years
iTrader: (1)
 
Joined: Mar 2004
Posts: 486
Likes: 1
From: NORWAY
or, to fix all rattles for good. do like me.
buy Big ******* stereo system with 3x10" woofers and blast away everytime you drive, works like a charm
Reply
Old May 21, 2010 | 09:46 AM
  #19  
f2racer's Avatar
Senior Member
Tenured Member 15 Years
iTrader: (1)
 
Joined: Mar 2001
Posts: 379
Likes: 0
From: Bedford, MA, USA
Originally Posted by RX 4 Speed
Another thing that rattles, sounds like it's from the front dashboard, by the vents, kindda sounds like a squeak-squeak, gets loud when traveling on city streets. Turns out it's the hood latch. To fix it, I applied a little duct tape around the latch that gets hooked by stationary hook in the engine bay. Squeak/rattle is gone!!! Hope that helps someone too.
RX4, great find. I've been hunting for my dashboard squeak source since I bought my last FD (back in 2000) with no luck. Searched on the forum, found this thread, a little duct tape and squeak is gone!

Thanks
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
musker
New Member RX-7 Technical
1
Oct 1, 2015 05:58 PM
SSpyderX
1st Gen General Discussion
0
Sep 29, 2015 04:37 PM




All times are GMT -5. The time now is 09:44 PM.