ABS lamp is lit
ABS lamp is lit
One of the easiest things you can do without a diagnostic is to stick a multimeter on each sensor and spin the wheels and see if you can get a reading. The resistance of the sensors as they are sitting with out spinning is 800-1200 ohms.
While not often, most likely a wheel speed sensor failed, especially if its out
of the blue.
The abs system will output fault codes in a light flashing sequence if you stick a test lamp in the correct pin of the diagnostic plug
While not often, most likely a wheel speed sensor failed, especially if its out
of the blue.
The abs system will output fault codes in a light flashing sequence if you stick a test lamp in the correct pin of the diagnostic plug
Last edited by R-R-Rx7; Feb 1, 2023 at 01:42 PM.
The frequent thing to fail is the sensor at one of the wheel hubs. the wires often get stretched when people do a suspension install and neglect to unplug the wheel sensor to get enough slack to install the shock/spring.
The Factory Service Manual has the procedure and troubleshooting steps. You can download it from the link in the FAQ thread - https://www.rx7club.com/3rd-generati...l-links-68640/
The Factory Service Manual has the procedure and troubleshooting steps. You can download it from the link in the FAQ thread - https://www.rx7club.com/3rd-generati...l-links-68640/
Thread
Thread Starter
Forum
Replies
Last Post
