RX7Crazy_84

iTrader: (1)

hey guys i was wondering is 99 spec bumper pretty much bolt on?i just bought 99 spec bumper from my boss!! now i am just curious if it will just bolt right on when i take off stock bumper off!!

joeclams9

i think u have to modify the rebar

RX7Crazy_84

iTrader: (1)

what u have to do to the rebar

Herblenny

iTrader: (13)

Well, the signal lights are much bigger.. you'll have issues with fitting the new signals.

Quickfini

iTrader: (6)

You have to enlarge the holes for the 99 spec lights. Some people just hack off the ends, so it's up to you.

I just enlarged the holes a bit, but after cutting, there's not much material left anyway.

DGblk93

Here's a thread I started a few months ago about the same topic. You might find it useful.

https://www.rx7club.com/interior-exterior-audio-26/re-99-bumper-install-475114/

RX7Crazy_84

iTrader: (1)

any1 have pic or anything of what i have to large the holes for?

birdy01

or save yourself the work and just buy a 99' Rebar at rx7store.net or corksports.com.
The 99' Rebar will make a perfect fitment, plus you will benefit the additional 99' foglights if you prefer to have them on.

Rufio

what u guys talking about? i didnt have to modify mine at all...

birdy01

that's because you probably aren't even running on a Rebar. I see that FMIC, so you prob. took it off. IF the reinbar is taken off, than of course there's no modification to it whatsoever.

Rufio

ya i did take it off...but i dk what u were talkin about modifying for the turn lamps...mine popped right in

DaiOni

if you have the reinforcement bar - and it's a good idea to have it - then you need to enlarge the hole for the lamps (the original is the same size as the original lamps) - basically you just need to get it cut bigger (though I've seen some that look like a hammer was the only tool used...).

from this...


to this...


of course, if you read the link provided above - you will see everything you need to know

birdy01

Again you don't have a rebar that's why yours didn't have any fitment issue.
I was refering to the 93-95 Rebar. If you have the 93-95 stock rebar than you will have to cut the signal lights to make it bigger to fit the 99 Combo Lights.