850cc in primary problem.
#1
I'm sorry wha?
Thread Starter
850cc in primary problem.
So I milled my primary rail down 1/8 an inch to fit my 850s...problem is I cant get them to sit down all the way in the rail....Am I supposed to bore out the inside too?
#2
Cant be bothered anymore
Join Date: Aug 2004
Location: Norwich UK
Posts: 465
Likes: 0
Received 0 Likes
on
0 Posts
No.
You need to remove 2mm from the top. The tops should push the injector shoulder down on to the top.....Be careful that you dont catch the o rings. They are easy to tear...
Scott
You need to remove 2mm from the top. The tops should push the injector shoulder down on to the top.....Be careful that you dont catch the o rings. They are easy to tear...
Scott
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM