Hood Latch Pull Tab
#4
It took me 3 minutes total to post these pics--50 seconds to walk out to my car (sitting out in a separate garage), 10 secs to snap the pics, 50 secs to walk back to my computer, and the rest to load the pics onto the site. I know this is not high-level excitement, but I just want to see the factory setup for 'reference'.
Thx
Thx
#5
It took me 3 minutes total to post these pics--50 seconds to walk out to my car (sitting out in a separate garage), 10 secs to snap the pics, 50 secs to walk back to my computer, and the rest to load the pics onto the site. I know this is not high-level excitement, but I just want to see the factory setup for 'reference'.
Thx
Thx
The following users liked this post:
DaleClark (10-19-20)
#6
Thanks Madhat. That's the way I thought it was to start with, but it would not open the latch. I obviously have some other problem with the latch/cable mechanism. This helps a lot. I can rule out one possible cause. Thanks for taking a moment to snap some pics.
David
Edit: No charge for the 'snark'.
David
Edit: No charge for the 'snark'.
Last edited by getgone; 10-18-20 at 12:57 AM.
#7
RX-7 Bad Ass
iTrader: (55)
Typically the hood end of the cable is what has problems - it breaks off or the latch gets jammed. The interior part typically stays OK.
Dale
Dale
The following users liked this post:
Natey (10-20-20)
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
AWD-RWD racer
3rd Generation Specific (1993-2002)
2
01-05-11 12:30 PM