Automatic bell housing size
Automatic bell housing size
Hello
I tried searching before I posted this thread, can someone tell me what is the size (length) of the automatic bellhousing of a FD? Thank you!
I tried searching before I posted this thread, can someone tell me what is the size (length) of the automatic bellhousing of a FD? Thank you!
Joined: Oct 2001
Posts: 6,279
Likes: 728
From: Florence, Alabama
bellhousing depth is 6 9/16 inches
rear flange is .6 thick w 10 bolt holes. i milled a quarter inch off mine to deepen the input shaft penetration of the pilot bearing.
works fine
Howard
rear flange is .6 thick w 10 bolt holes. i milled a quarter inch off mine to deepen the input shaft penetration of the pilot bearing.
works fine
Howard
Thread
Thread Starter
Forum
Replies
Last Post
SakeBomb Garage
Group Buy & Product Dev. FC RX-7
69
Oct 13, 2023 02:03 PM
Chad Dickerson
1st Generation Specific (1979-1985)
7
May 28, 2016 04:42 PM
MattGold
3rd Generation Specific (1993-2002)
4
May 25, 2016 09:38 PM