Factory alarm problems

 
Thread Tools
 
Search this Thread
 
Old 08-15-01, 03:40 PM
  #1  
Senior Member

Thread Starter
 
mr_jonboy's Avatar
 
Join Date: Apr 2001
Location: Phoenix, AZ
Posts: 256
Likes: 0
Received 1 Like on 1 Post
Unhappy Factory alarm problems

My car has been out of commision for about two weeks or so from other things that I have been doing. I just started it a few days ago to move it and noticed that the security system wasn't arming when I locked the doors. I didn't think much of it at the time. The next day I got the things down with the car and went for some test runs. I figured by then the battery would be fully charged back up and then the alarm might function again. But to my amazement it still did not arm. Has anyone had this problem or know how to fix it?

Thanks in advance,
mr_jonboy is offline  
Old 08-16-01, 12:56 AM
  #2  
Full Member

 
Rix7's Avatar
 
Join Date: Mar 2001
Location: home of the big chrome wheel homies
Posts: 225
Likes: 0
Received 0 Likes on 0 Posts
That happened to me once...where you lock it and shut the door, but then it just unlocks itself again, right? All I did to correct it was turn my key to the "ON" position (no start-up and with all doors/trunk/hood shut) and let it go through the beeping it does, then I just took the key out and tried to lock the car again. Worked like a charm. Not sure to this day why that happened that one time though.
Rix7 is offline  
Old 08-16-01, 10:01 AM
  #3  
Senior Member

Thread Starter
 
mr_jonboy's Avatar
 
Join Date: Apr 2001
Location: Phoenix, AZ
Posts: 256
Likes: 0
Received 1 Like on 1 Post
I will try what you did to see if that does anything, but I believe when I shut the doors and locked it that it stayed locked but just didn't turn the security on. I will recheck it tonight but I think it was staying locked when I shut the door. Thanks for the info though.
mr_jonboy is offline  
Old 08-16-01, 12:32 PM
  #4  
Full Member

 
R1 POWR's Avatar
 
Join Date: Apr 2001
Location: SC
Posts: 102
Likes: 0
Received 0 Likes on 0 Posts
jonboy,

if any of the sensors are "open" then the system won't arm. i would check the door sensors, hood sensor, & rear hatch sensor. one of those sensors is probably bad (or disconnected). you said your car was "out of commission" -- if you're doing any work to the front of the car, i would especially check the hood sensor.

good luck.

R1 POWR is offline  
Old 08-16-01, 12:44 PM
  #5  
Senior Member

Thread Starter
 
mr_jonboy's Avatar
 
Join Date: Apr 2001
Location: Phoenix, AZ
Posts: 256
Likes: 0
Received 1 Like on 1 Post
Where can I find these sensors? Are they shown on the workshop manual?
mr_jonboy is offline  
Old 08-17-01, 10:45 AM
  #6  
Full Member

 
R1 POWR's Avatar
 
Join Date: Apr 2001
Location: SC
Posts: 102
Likes: 0
Received 0 Likes on 0 Posts
jonboy,

the hood sensor is located under the latching mechanism?? i think it's kind of a bitch to get to (unless you already have your front bumper off -- or maybe if you just pull the entire latch mechanism out all together, it'll probably come out with it. -- i've never actually seen it, so i'm purely guessing at this point). the door "sensors" are probably the same ones that control the interior dome/courtesy lights. if the dome/courtesy lights don't come on when you open either door, then it could either indicate a blown bulb or a bad door "sensor". the rear hatch sensor, i would guess, is very similar to the one used on the hood.

i haven't checked, but i would think that it would be in the shop manual, too.

again,.....good luck.......

R1 POWR is offline  
Old 08-17-01, 10:47 AM
  #7  
Senior Member

Thread Starter
 
mr_jonboy's Avatar
 
Join Date: Apr 2001
Location: Phoenix, AZ
Posts: 256
Likes: 0
Received 1 Like on 1 Post
Thanks for all the info, but I got it fixed somehow. I did what Rix7 said and amazingly it worked. WEIRD. Again thanks for the info.
mr_jonboy is offline  
Old 08-17-01, 11:33 PM
  #8  
Full Member

 
Rix7's Avatar
 
Join Date: Mar 2001
Location: home of the big chrome wheel homies
Posts: 225
Likes: 0
Received 0 Likes on 0 Posts
Originally posted by mr_jonboy
Thanks for all the info, but I got it fixed somehow. I did what Rix7 said and amazingly it worked. WEIRD. Again thanks for the info.
All right dood! Congrats!
Rix7 is offline  
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
ZacMan
Build Threads
4
09-19-15 09:20 PM
ls1swap
3rd Generation Specific (1993-2002)
15
09-08-15 05:30 PM



Quick Reply: Factory alarm problems



All times are GMT -5. The time now is 05:49 AM.