Hey,
Does anyone know the wires for the audio component? For example. (blu/brn front right speaking (+) ) like that for the radio. When I got the car awhile ago the harness was cut to craps. I basicly have to hard wire the cd player now. So if anyone can answer this or show me a picture of what every wire for the audio, that would be awsome. Thanks in advance.

Oh yeah checked haynes manual all it said was nothing helpful. Did searched and found nothing.

(I don't remember which is which wire anyways.)

Thanks in advance.


Edit: of yeah, car is 89 gxl.

 

hey before anyone flames the **** out of you, save yourself and read the FAQ sticky at the top. it has like everything that you need to know. hope it goes well

 

already read it doesn't give much help.

Edit: nevermind I just remember I tried the other night. The sites that load up won't let me look at ****. So if anyone can open it up for me, and post the wiring diagram for me. It would be great. Oh yeah my computer sucks crap like that.

 

well you could always try the "what happenes when i conect these 2 wires" method. just be careful about the ground. make sure the ground is grounded to the frame! you dont want to burn out your light switch

 

What are the wire colors for adding aftermarket radio
LTBlue/Red= 12v+
LtBlue/White= +Accessory
LtBlue/Yellow= -power ant trigger
Red/Black=+ Lumination
White=Factory Amp Turn on

Ground to the body, use the 10mm bolt behind the center console front drivers access panel. Do not use the Red/Black as ground it will damage the interior light circuit and dimmer in the car

Front Speakers (maximum of a 15 watt peak from the radio):
LtGreen/Red= Left
LtGreen/Black= Left

LtGreen= Right
LtGreen/Yellow=Right

Rear Speakers (if applicable, if you have the amplified rear speakers again the Maximum of 15 watts peak is all the stock speaker amp input can handle):
Brown= Left rear
Brown/White= Left Rear

LtBlue= Right Rear
LtBlue/Orange=Right Rear

Note: as mentioned above the power antenna's trigger is ground (or - ). With all aftermarket radio's antenna output as 12 volts positive (+). To make a stock power antenna work you need a relay wired like this:

 

lol, already tried that... I burnt up 6 fuses in under 2 minutes. On top of that the alpine I got doesn't have a working face plate. But I know which one are the rear ones.

 

whoa, i would stop while your ahead, find out which wires are hot always, which ones are hot in acc , then ground your ground. you shouldnt be blowing fuses

 

I started from scratch and ran my own speaker wiring throughout the car as well as the wiring to the 12 disc CD changer. Its not rocket science.