where to start
Thread Starter
Junior Member
Joined: Sep 2002
Posts: 23
Likes: 0
From: Hesperia Michigan
I just put my 1991 rx-7 on the road and am looking to start modifying my car i'm not quite sure where to start and am looking for a direction to start...can you give me some help
kev
kev
Always the first place to start is a general tune-up if you haven't already - new spark plugs and wires, change the fuel filter, change the oil, flush the radiator, etc.
As far as performance, easiest first mod is a cone intake. Cheap and takes about 10 minutes to install.
Dale
As far as performance, easiest first mod is a cone intake. Cheap and takes about 10 minutes to install.
Dale
Exhaust! It's all about the exhaust. Plugs aren't going to gain you much if any with no other mods. Unless of course you need to replace your current ones anyways. Exhaust will yeild you the most power over any other mod on an N/A, except for Nitrous. Check out www.racingbeat.com or mazdatrix, they offers a nice system too. www.mazdatrix.com
You have four spark plugs on your car. There are two per rotor. One leading one trailing. It has to do with how the combustion chamber in a rotary is shaped. In order to get a good burn it required the use of leading and trailing plugs.
Might want to invest in a haynes manual, or the factory service manual. Hope that helps! Good luck on your car!
Steven
You have four spark plugs on your car. There are two per rotor. One leading one trailing. It has to do with how the combustion chamber in a rotary is shaped. In order to get a good burn it required the use of leading and trailing plugs.
Might want to invest in a haynes manual, or the factory service manual. Hope that helps! Good luck on your car!
Steven
Trending Topics
Originally posted by zero_coolest
it's non turbo...and i don't think i would put ever put windshield washer lights on my car...
it's non turbo...and i don't think i would put ever put windshield washer lights on my car...
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
Adaptronic Cranking fuel table messed up?
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM






