i am going to go with a FMIC and i was wondering what would be the best size IC to go with and if there is anyplace where i can buy IC piping instead of bending it myself?

 

ebay...intercooler and piping is the cheapest way to go i have an ebay intercooler and it works very well the piping usually isnt simple bolt on but you can bend and cut it to make it fit

 

well, whats your power goal? anything under 350rwhp 2 1/2" is more that enough.... but after that, start thinking about 3" piping.....

yeah, ebay is gonna be your cheapest bet.... i got a 12x24x3 intercooler and 3" piping for $470..

 

im not gonna be anywhere near 350 unless i spray. i found an IC on ebay but i cant find the right piping and i looked all over the place. there is one place but i dont want to spend 1k. im just gonna be running 10 psi out of the stock turbo.


how would i make this kit work cause i know some of these pipes dont have the right bends

http://cgi.ebay.com/ebaymotors/2-5-I...spagenameZWDVW

 

here is the piping i used from ebay.... i used all 8 pieces also... but heres what the finished product looks like... it only took 2 hours to do from start to finish

http://cgi.ebay.com/ebaymotors/ws/eB...RK%3AMEWN%3AIT


all you need are simple hand tools

 

how did you bend that your self? did you take it to a shop and have it done?

 

Vipers, that is a super clean install. Have you finished your swap yet?

 

no, if you go to the link i posted, the pipes are already bent... all i did was cut them to the lengths i needed.... its actually very simple to do



well, its 90% complete... its at guitarjunkie28's right now getting all the finishing touches done... should be running by friday *crosses fingers*

 

vipers are you running the stock turbo? it doesnt look like it. but i see how you did it.

 

will this kit work for a bolt up with some cutting??

piping kit

 

buy some univeral bends and make it yourself or take it to a muffler shop and have them bend all the pipes for you with a mandrel or smooth bender

 

'Vipers' i wish i woulda got that kit 8 90 degree bends would've been better than the kit that 'rx7_TII' is talking about to hard to install, 'vipers' is smoother and looks easier to do

 

yeah, i wouldnt go w/ that kit... looks like you have to really think about which pipes to use and where to use them.... mine was simple... i had no choice but to use 90 degrees... but to me, the final look is exactly what i wanted....

 

nope.. its a master power t-70 w/ 1.00ar hotside

 

vipers right mine is way complicated, his seems a lot easier...





i just like the last one it has nothing to do with this thread lol