What Size Are The Fuel Pump Flange Screws?
#1
Full Member
Thread Starter
Join Date: May 2004
Location: Connecticut
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
What Size Are The Fuel Pump Flange Screws?
... or where to find the size of the screws that hold the fuel pump in on the gas tank? The old ones are mostly destroyed cause of rust.
For that matter, anyone have a favorite website for buying size specific screws? Pep-boys just ain't doin it for me.
For that matter, anyone have a favorite website for buying size specific screws? Pep-boys just ain't doin it for me.
#4
Hey...Cut it out!
iTrader: (4)
M4 x 0.7 x 8mm length (10mm long with screw head)
I just took mine to lowes and matched them up. Closest match was M4 x 0.7, 10 mm length without head. The extra 2mm shouldn't matter too much, but if you're picky about it, get some washers for $0.50.
They are available in cap screws (allen wrench type) and hex head both, 4 for $0.80. The UPC number for the hex head bolts is 009236710298
Bit of advice though: To make replacing them easier, leave at least two of the old ones in to get the holes to match up, it makes it a LOT easier.
Icemark, if you see this, please add it to the Nut/Bolt/Screw thread guide if it's not already there.
I just took mine to lowes and matched them up. Closest match was M4 x 0.7, 10 mm length without head. The extra 2mm shouldn't matter too much, but if you're picky about it, get some washers for $0.50.
They are available in cap screws (allen wrench type) and hex head both, 4 for $0.80. The UPC number for the hex head bolts is 009236710298
Bit of advice though: To make replacing them easier, leave at least two of the old ones in to get the holes to match up, it makes it a LOT easier.
Icemark, if you see this, please add it to the Nut/Bolt/Screw thread guide if it's not already there.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
ChrisRX8PR
Single Turbo RX-7's
21
10-18-15 04:01 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM