What kinda hp should I expect with this?
Thread Starter
Full Member
Joined: Feb 2002
Posts: 59
Likes: 0
From: Bay Area
What kinda hp should I expect with this?
I'm a little courious as to what I can expect to get.
I'm just starting rip apart my 89 TII and here's what I'm installing over the next week or so.
Haltech E6K
3" RB exhaust system
Greddy FMIC
550 primary, 800 secondary (rc engineering)
3rd gen pump
ported engine w/ 3mm seals (rx7 specialties, Calgary)
Profec B
-Matt
I'm just starting rip apart my 89 TII and here's what I'm installing over the next week or so.
Haltech E6K
3" RB exhaust system
Greddy FMIC
550 primary, 800 secondary (rc engineering)
3rd gen pump
ported engine w/ 3mm seals (rx7 specialties, Calgary)
Profec B
-Matt
Senior Member
Joined: Oct 2001
Posts: 674
Likes: 1
From: Bay Area CA
That sounds about right. Why are you going with the RB full exhaust? I hear its pretty restrictive and so I went with a single N1 exhaust. The N1 may be loud as heck but it sure relieved a lot of backpressure.
- kevin
- kevin
Thread Starter
Full Member
Joined: Feb 2002
Posts: 59
Likes: 0
From: Bay Area
From what I've been told it's the best flowing bolt on exhaust for an FC.
I know a few people running it with no complaints.
It's pretty quite as well. I don't like the N1 cause it's way too loud for my liking and I like the dual exhaust look.
I know a few people running it with no complaints.
It's pretty quite as well. I don't like the N1 cause it's way too loud for my liking and I like the dual exhaust look.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM