deevious

So this must be pretty straight forward as I can't find any thread describing this in detail. I did find a thread that indicated you should tap into the water pump, but is there no way to install it without drilling???
BTW I have a VDO electrical with temp sensor (I'll have to look up the exact size of the sensor).
Any help is more than welcome as usual.

JerryLH3

iTrader: (11)

Read this thread about my radiator installation for how I installed the sender for the water temp gauge.

deevious

Ah good stuff and an interesting read. Thx

NZConvertible

Basically no. it appears that no aftermarket gage senders use the same thread as the stock gauge sender on the rear plate, and the next best location is on the back of the water pump. if you don't have the tools to drill and tap a new hole then take the pump and sender to a mechanic or engineering shop. It'll probably only take them ten minutes.

Net Seven

iTrader: (5)

Can someone please put up a picture of where exactly on the back of the water pump the sensor should be place? Thanks

Net Seven

iTrader: (5)

No one has pics?

Nova7

iTrader: (5)

Sorry to resurect this thred, but I too would really appreciate a picture of the water pump tapped for a new sender, on or off the engine.