Just wanted to confirm that all four injectors are the same for my 87 NA FC. Sending em out to get cleaned and flowed, and also getting new O-rings, and Grommets.

195599-1350. Thats what it says in the FAQ, i just thought they had different ones for Primary and Secondary



Also the clips for the primary injectors, i think i may have broken the plastic peice. Do i need to get new ones or will the metal spring hold them in place when i put them back.

Thanks in advanced

Jason NYC
NYRA Prez
www.nyrotary.com

 

yes they are all the same, and which plastic piece? As long as the metal clip is held onto the pigtails, they should be ok. But doesnt hurt to order some new ones, they only run about 5.00 a piece

 

thanks for the reply. Not the square plastic holder. Just one end of the corner peice where the peice of metal is bent is cracked. The entire structure of thee plastic square is preserved.

Jason NYC

 

I would say that as long as most of the connector is intact you should be fine. As for the injectors, in stock form the primaries are always the same as the secondaries, so yours are correct.

 

k, thanks, just wanted to make sure they were all the same. If they never been cleaned you guys think i can squeeze a few more MPG from them.

One of them looked different than the rest. The top of the Injector where theres some type of mesh on the inside was really covering the area where the fuel enters. The other 3 the mesh was pushed to the side and you can see a lil further in. Dont know if the single or the other 3 are the norm.

Jason NYC

 

the mesh is suppose to be there, although all i can think of what they are for are post filtration.

 

i figured that they are supposed to be there. But are they suppose to be covering the opening where teh fuel enters? I guess its an added protection for more filtration of the fuel, in case your FF misses something.

Jason NYC