vacuum leak hell
#26
ITS ME!!!
Thread Starter
Join Date: Sep 2006
Location: Kenner, LA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
ok i fixed the big leak but now the car is idlin at 4000rpms when i rev it up to 5000 it sits for a second an then slowly drops back down an the lowest it will idle is about 3600rpms. I cant get it to drop any lower than that
#28
ITS ME!!!
Thread Starter
Join Date: Sep 2006
Location: Kenner, LA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
the apex seals were changed less than 20,000 miles ago but my dumbass went out an blew the coolant seals i put a little stop leak in it an it seems to be helpin. but i cant figure out why its idlin so high. I drove it around the block an it lacks power ungodly
#30
ITS ME!!!
Thread Starter
Join Date: Sep 2006
Location: Kenner, LA
Posts: 300
Likes: 0
Received 0 Likes
on
0 Posts
OK well i just drove it to my parents house an it didnt do to good it has no power whatsoever a pinto could beat me an i have that 3800rpm hesitation thing. but when i pop the clutch it pulls for a second an then drags *** an of course every time i press the clutch the car revs up a little an sits. you really think i have a blown rotor cause the weird part of all this is that before a pulled the motor all it did was run hot after about ten miles an now i'm havin all these problems after i put the same motor back in the car didnt change hardly anything i dont understand
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
gabescanlon
3rd Generation Specific (1993-2002)
4
09-05-15 12:04 AM