Turbine Housing Hitting the Lower Intake Manifold
#26
B O R I C U A
iTrader: (14)
What rectangular tube did you use between the flanges?
This btw, is my Cherokee. This kinds shows some of my welding.... Built a new unibody frame in the back, boxed in the "bed" and 4 link rear end. Was my daily driver too until more computer issues. Now I'm tracking down a small block chevy and 700R4 transmission for it and 1 ton axles...
The tan was before it was finished hint the raw steel bed and such. The blue and silver is as it sits now.
This btw, is my Cherokee. This kinds shows some of my welding.... Built a new unibody frame in the back, boxed in the "bed" and 4 link rear end. Was my daily driver too until more computer issues. Now I'm tracking down a small block chevy and 700R4 transmission for it and 1 ton axles...
The tan was before it was finished hint the raw steel bed and such. The blue and silver is as it sits now.
#28
Well, I followed your advice and three everything together quickly to check my clearances. Everything looks good and I have about 4 inched between the turbo and the strut tower. Now im wondering about my exhaust downpipe. My turbo manifold seems to ouch the turbo forward a ways so im wondering if I will be able to get any typical aftermarket downpipe to work or will I have to build one?
#31
B O R I C U A
iTrader: (14)
Well, I followed your advice and three everything together quickly to check my clearances. Everything looks good and I have about 4 inched between the turbo and the strut tower. Now im wondering about my exhaust downpipe. My turbo manifold seems to ouch the turbo forward a ways so im wondering if I will be able to get any typical aftermarket downpipe to work or will I have to build one?
Thread
Thread Starter
Forum
Replies
Last Post