DC350

I have a dual exhaust. From an N/A with 2 mufflers. Fairly loud with a race pipe

My question is If You had a turbo II would you go with a 3 " corksport. Even though some people say it is a nice sounding exhaust, I do not like the sound very much.

Could one get custom piping from the downpipe to the Y-pipe (3 inched piping) and still work good? I dont want to get rid of mine because it is so such a low deep tone

Thanks, Evan

2a+RoN

yeah it should work fine with a 3'' midpipe. it'll be great flow too, better than the corksport cuz that is actually a 2.5'' flared to 3''. I have a rb dp and custom 3'' piping all the way back to a single N1 and I love it!

DC350

Good, that settles it!

3" DP and Mid pipe..... to the y-pipe damn it's going to be LOUD

colin204

get the www.thunderfabrications.com downpipe/midpipe

Ryde _Or_Die

Just remember a TII doesn't sound the same as an NA. IMO it sounds much much better.

sbertolone

loud my car is loud i have the 3 inch rb dp with just the presilencer on it, its just a straight through drilled core muffler

2a+RoN

remember that the thunderfab dp/mp combo is not full 3'', it goes back down to 2.5'' at the y.

2a+RoN

yeah i love the sound of my tII, but it is quite loud.

Rotorific

iTrader: (1)

custom all the way

sbertolone

its hard to find a place that will mandrel bend 3 inch pipes for you, so i would buy a 3inch dp go to a 3 inchmuffler off of that, with dual 2.5 inch outs, a lot of places have a bender that will do that size

Rotorific

iTrader: (1)

Any big time shop can mandrel bend you a 3 inch pipe they can mandrel bend up to 4.5 inch pipes.

banzaitoyota

and who in Disgusta can Mandrel bend?

sbertolone

all the shops by me only do up 2.5, the big mandrel benders are expensive and would rarely get used there not good investments